BRZ STi front lip install

The BRZ STi front lip install is on!

The instructions available for installing the BRZ STi lip are specific to pre-2017 cars, so it was a little bit tricky to figure out. I did have help from another BRZ enthusiast on the FT86club forums. Following these instructions, the BRZ STi front lip install process was fairly straightforward. I was able to successfully install the BRZ STi lip on my own 2017 BRZ. The BRZ STi lip adds an aggressive look to an already great looking car. In my case, I am also using it for a little bit of autocross cone protection for the front bumper 🙂 Be careful though, since the lip hangs down about 1.5″ from the normal bumper, it becomes a bit of a ground clearance hazard.

BRZ STi front lip un-boxing

Subaru BRZ STi front lip un-boxing

A shiny new BRZ STi front lip for my 2017 BRZ!

It’s not often that I get cosmetic upgrades for my cars, but this BRZ STi front lip looks too good to pass up. The front under-spoiler is from the Subaru accessory catalog, so it is a genuine Subaru STi part. The front lip gives the car a lower, more aggressive look. In addition, it will help protect the real bumper from potential dings and impacts. This is especially important when you autocross the car like I do. Nothing like built in cone protection for your shiny new bumper 🙂 You can order your own lip directly from your local Subaru dealership. Check out the video as Shelby and I un-box the BRZ STi front lip! Check back soon for the installation video as well.